Installing Thermostat; Installing The Oil Filter; Installing Gear Position Sensor - KTM 690 Enduro R EU 2012 Repair Manual

17 ENGINE

17.5.27 Installing thermostat

17.5.28 Installing the oil filter

17.5.29 Installing gear position sensor

–
Put on the water pump cover
Guideline
Screw, water pump cover
300012-12
–
Position the thermostat
The drill hole
–
Install the thermostat case
–
Mount and tighten the screws.
Guideline
Screw, thermostat housing
300010-11
–
Insert the oil filter
–
Lubricate the O-ring of the oil filter cover. Install the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
300009-11
–
Insert the oil filter
–
Lubricate the O-ring of the oil filter cover. Install the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
306801-11
–
Mount the contact springs
The contact bolts are mounted with the flat side forward; the pointed sides
face the sensor.
–
Position O-ring
300007-11
. Mount and tighten screws.
5
with the gasket.
1
must face upward.
A
with the radiator hose.
2
M6
.
1
.
3
and contact bolt
1
.
3
M6 10 Nm (7.4 lbf ft)
10 Nm Loctite
(7.4 lbf ft)
.
2
M5 6 Nm (4.4 lbf ft)
.
4
M5 6 Nm (4.4 lbf ft)
.
2
161
® 243™