How To Attach An Ipv6 Snooping Policy To Vlans Globally; How To Configure The Ipv6 Binding Table Content - Cisco Catalyst 2960-XR Security Configuration Manual

How to Attach an IPv6 Snooping Policy to VLANs Globally

How to Attach an IPv6 Snooping Policy to VLANs Globally
Beginning in privileged EXEC mode, follow these steps to attach an IPv6 Snooping Policy to VLANs across
multiple interfaces:
SUMMARY STEPS
1. configure terminal
2. vlan configuration vlan_list
3. ipv6 snooping [attach-policy policy_name]
4. do show running-config
DETAILED STEPS
Command or Action
Step 1 configure terminal
Example:
Switch# configure terminal
Step 2 vlan configuration vlan_list
Example:
Switch(config)#
Step 3
ipv6 snooping [attach-policy policy_name]
Example:
Switch(config-vlan-config)#ipv6 snooping
attach-policy example_policy
Step 4
do show running-config
Example:
Switch#(config-if)# do show running-config

How to Configure the IPv6 Binding Table Content

Beginning in privileged EXEC mode, follow these steps to configure IPv6 Binding Table Content :
Catalyst 2960-XR Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX1
356
vlan configuration 333
Purpose
Enters the global configuration mode.
Specifies the VLANs to which the IPv6 Snooping policy will be
attached ; enters the VLAN interface configuration mode.
Attaches the IPv6 Snooping policy to the specified VLANs across
all switch and stack interfaces. The default policy is attached if
the attach-policy option is not used. The default policy is,
security-level guard, device-role node, protocol ndp and dhcp.
Verifies that the policy is attached to the specified VLANs without
exiting the interface configuration mode.
Configuring IPv6 First Hop Security
OL-29434-01