Filling The Reservoir - Yamaha F115A Service Manual

Hide thumbs Also See for F115A:

Table of Contents

RESERVOIR AND POWER TRIM AND TILT MOTOR

FILLING THE RESERVOIR

To prevent the hydraulic fluid from spurt-

ing out due to internal pressure, the tilt

ram should be kept at full length.

Recommended power trim and

ATF Dexron II

• Power trim and tilt fluid level

Level is low → Add power trim and tilt

fluid to the proper level.

BLEEDING THE POWER TRIM AND

This bleeding must be done before install-

ing the power trim and tilt unit onto the out-

• Air bubbles

(from the power trim and tilt unit)

Bleeding steps

(1) Set the power trim and tilt unit upright.

(2) Connect the leads of the power trim

and tilt on the battery terminals until

the trim and tilt ram assemblies are

fully compressed.

If the rams will not go down, refer to the fol-

A. Connect the leads of the power trim and

tilt on the battery terminals until the trim

extended. Then, reverse the leads on the

battery terminals until the trim and tilt

ram assemblies are fully compressed.

Show Quick Links

Table of Contents

F115y Fl115a Lf115y Fl115y