Accton Technology ES4626 Management Manual page 487

(2) Configure IGMP query parameters.
a. Configure transmission interval of query packets in IGMP
b. Configure maximum response time for IGMP queries
c. Configure timeout setting for IGMP queries
(3) Configure IGMP version
2、 Disable IGMP
1. Enable IGMP
There is no special command for enabling IGMP in layer3 switches, the IGMP
automatically enables when any multicast protocol is enabled on the respective interface.
Command
Interface Mode
ip dvmrp | ip pim dense-mode | ip
pim sparse-mode
2. Configure IGMP sub-parameters
(1) Configure IGMP group parameters.
a. Configuring IGMP group filtering criteria
b. Configure IGMP groups
c. Configure static IGMP groups
Command
Interface Mode
ip igmp access-group {<acl_num |
acl_name>}
no ip igmp access-group
ip igmp join-group <A.B.C.D >
no ip igmp join-group <A.B.C.D >
ip igmp static-group <A.B.C.D >
no ip igmp static -group <A.B.C.D
>
(2) Configure IGMP query parameters.
a. Configure transmission interval of query packets in IGMP
b. Configure maximum response time for IGMP queries
c. Configure timeout setting for IGMP queries
Command
Explanation
Enable IGMP protocol;
command
sparse-mode"
protocol (required)
Explanation
Set the filter criteria for IGMP group on the
interface; the "no ip igmp access-group"
command cancels the filter criteria.
Join the interface to an IGMP group; the "no
ip igmp join-group" command cancels the
join.
Join the interface to a static IGMP group; the
"no ip igmp static -group" command
cancels the join.
Explanation
487
the "no
pim
disables IGMP