Accton Technology ES4626 Management Manual page 107

Accton layer 3 gigabit switch management guide
Table of Contents

Advertisement

Parameter: <string> is a string, up to 32 characters are allowed.
Command mode: Interface Mode
Default: No name is set by default.
Usage Guide: This command facilitates the management of the switch. The user can
name the ports according to their usage, for example, 1/1-2 ports used by the financial
department, and they can be named "financial"; 2/9 port is used by the engineering
department, and can be named "engineering"; 3/12 port connects to the server, and can
be named "Servers". Thus the usage of the ports are obvious.
Example: Name ports 1/1-2 as "financial".
Switch(Config)#interface ethernet 1/1-2
Switch(Config-Port-Range)# descriptionfinancial
3.2.1.2.8
Command: negotiation no negotiation
Function: Enable the auto-negotiation function of 1000Base-FX port. Use the "no"
command to disable the auto-negotiation function of 1000Base-FX port. Command mode:
Port configuration Mode
Default: Auto-negotiation is enabled by default.
Usage Guide: This command applies to 1000Base-FX interface only. The
command is not available for 1000Base-TX or 100Base-TX interface. . For combo port,
this command applies to the 1000Base-FX port only and has no effect on 1000Base-TX
port. To change the negotiation mode, speed and duplex mode of 1000Base-TX port, use
speed-duplex command instead.
Example: Port 1 of Switch1 is connected to port 1 of Switch2, the following will disable the
negotiation for both ports.
Switch1(Config)#interface e1/1
Switch1(Config-Ethernet1/1)# no negotiationSwitch2(Config)#interface e1/1
Switch2(Config-Ethernet1/1)#negotiation
3.2.1.2.9
Command: rate-suppression {dlf | broadcast | multicast} <packets>
no rate-suppression {dlf | broadcast | multicast}
Function: Sets the traffic limit for broadcast, multicast and unicast for unknown
destination on all ports in the switch; the "no rate-suppression" command disables the
traffic throttle function of broadcast, multicast and unicast for unknown destination on all
ports in the switch, i.e., enable broadcast, multicast and unicast for unknown destination
negotiation
rate-suppression
107
negotiation

Advertisement

Table of Contents
loading

This manual is also suitable for:

Es4650

Table of Contents