Accton Technology ES4626 Management Manual page 474

[no] ip dvmrp
2. Configure connectivity with CISCO routers/switches
CISCO does not really implemented DVMRP, but provides connectivity with DVMRP. As
CISCO routers/switches send report packet but not probe packets, neighbor timeout issue
should be addressed in establish connectivity with CISCO routers/switches. The following
command makes a DSRS-5950 switch to decide the timeout of a neighbor by report
packet intervals.
Command
Interface Mode
[no] ip dvmrp cisco-compatible
<A.B.C.D>
3. Configure DVMRP sub-parameters
(1) Configuring DVMRP interface parameters.
a. Configure metric value for DVMRP report packet
b. Configuring DVMRP neighbor timeout time
Command
Interface Mode
ip dvmrp metric <metric_val>
no ip dvmrp metric
ip dvmrp nbr-timeout <time_val >
no ip dvmrp nbr-timeout
(2) Configuring DVMRP global parameters.
a. Configure transmission interval of graft packets in DVMRP
b. Configure transmission interval of probe packets in DVMRP
c. Configure transmission interval of report packets in DVMRP
Command
Global Mode
ip dvmrp graft-interval <time_val>
no ip dvmrp graft-interval
ip dvmrp
<time_val>
no ip dvmrp probe -interval
Enable DVMRP; the "no ip dvmrp enable"
command disables DVMRP (required)
Explanation
Enable connectivity with CISCO neighbor A,
B, C, D; the "no ip dvmrp cisco-compatible"
command disables connectivity with CISCO
neighbors.
Explanation
Set interval for sending DVMRP report
packets in the interface; the "no ip dvmrp
metric" command restores the default setting.
Set timeout interval for DVMRP neighbors in
the interface; the "no ip dvmrp nbr-timeout"
command restores the default setting.
Explanation
Set the interval for sending DVMRP graft
messages; the "no ip dvmrp graft-interval"
command restores the default setting.
Set the interval for sending DVMRP probe
probe-interval
messages; the "no ip dvmrp probe interval"
command restores the default setting.
474