Accton Technology ES4626 Management Manual page 337

drop and policied-dscp-transmit, the latter is by a mapping function between given
DSCP and corresponding policy and mark the DSCP into the packet.
Operation type－Set or Remove.
To configure Policy-map bandwidth configuration, select p1 to Policy-map name, input c1
to Class-map name, all sections choose as default setting, select Set to Operation type,
then click Apply.
13.1.5.3.4 Add/Remove Aggregate Policer
Click Add/Remove aggregate policer to entry configure page. I is equivalent to CLI
command 13.1.2.2.8.
All sections describe as following:
Aggregate policer name
Rate－average baud rate for classified bandwidth, K bit/s per unit.
Burst－burst rate for classified bandwidth, K byte per unit.
Exceed-action－The action for once the data rate exceeds the rate limited, includes
drop and policied-dscp-transmit, the latter is by a mapping function between given
DSCP and corresponding policy and mark the DSCP into the packet.
To create the aggregate-policer, named as agg1, the definition of aggregate-policer is
based on the baud rate 20M Kbps, the burst rate 2M Kbyte. All packets will be dropped
whenever over the assigned running rate. After setting all value, then click Add.
13.1.5.3.5 Apply Aggregate Policer
337