Configuration Scenario - Accton Technology ES4626 Management Manual

Mask
Nexthop
Interface
Pref
15.2.4

Configuration Scenario

The figure below is a simple network consisting of three ES4626/ES4650 layer3 switches,
the network mask for all switches and PC IP addresses is 255.255.255.0. PC1 and PC3
are connected via the static route set in Swtich1 and Switch3; PC3 and PC2 are
connected via the static route set in Swtich3 to Switch2; PC1 and PC3 is connected via
the default route set in Switch2.
PC1：10.1.1.2
vlan1： 10.1.1.1
SWITCH-1
Configuration steps:
Configuration of layer3 switch Switch-1
Switch#config
Switch(Config)#ip route 10.1.5.0 255.255.255.0 10.1.2.2
Configuration of layer3 switch Switch-3
Switch#config
！Next hop use the partner IP address
Switch(Config)#ip route 10.1.1.0 255.255.255.0 10.1.2.1
Mask of the destination network
Next hop IP address
The layer3 switch interface to next hop.
Route priority, if route of the other types
exist to the destination network, only the
route of the higher priority will be displayed
in the core route table.
PC3：10.1.5.2
vlan3：10.1.5.1
vlan2： 10.1.2.2
SWITCH-3
vlan2： 10.1.2.1
vlan1： 10.1.3.1
Fig 15-1 Static Route Configurations
366
PC2： 10.1.4.2
vlan1：10.1.3.2
vlan2： 10.1.4.1
SWITCH-2