Radius Authentication Configuration - Accton Technology ES4626 Management Manual

authentication and accounting）It is equivalent to CLI command 8.2.2.19.
System recovery time (1-255 minute) - Configure the recover time after RADIUS
server dead. It is equivalent to 8.2.2.18.
RADIUS Retransmit times(0-100) - Configure RADIUS authentication message
retransmit times. It is equivalent to CLI command 8.2.2.20.
RADIUS server timeout (1-1000 second) - Configure RADIUS server timeout timer.
It is equivalent to CLI command 8.2.2.20.
Choose Authentication status as Enable radius Authentication, select Accounting Status
as Enable Accounting, Configure RADIUS key as "aaa", Configure System recovery time
as 10 seconds, Configure RADIUS Retransmit times as 5 times, Configure RADIUS
server timeout as 30 seconds, Click Apply button, these configuration will be applied to
switch.

8.5.1.2 RADIUS authentication configuration

Click Authentication configuration, RADIUS client configuration, RADIUS authentication
configuration. Configure RADIUS authentication server IP address and monitor port ID. It
is equivalent to CLI command 8.2.2.17.
Authentication server IP ---Server IP address.
Authentication server port(optional) ---Is server monitor port ID, The range:
0~65535, the "0" means it's not work as authentication server.
Primary authentication server –-- Primary Authentication server, is primary server;
Non-Primary Authentication server, is non-primary server.
Operation type – Add authentication server, add authentication server; Remove
authentication server, remove authentication server.
Configure Authentication server IP as 10.0.0.1, Authentication server port as default port,
select Primary Authentication server, choose Operation type as "Add authentication
server", Click Apply button that is added an authentication server.
234