Accton Technology ES4626 Management Manual page 214

Command
Global configuration mode
dot1x macfilter enable
no dot1x macfilter enable
dot1x accept-mac
<mac-address>
<interface-name>]
no dot1x accept-mac
<mac-address>
<interface-name>]
dot1x eapor enable
no dot1x eapor enable
3. Some interrelated configuration about Supplicant
Command
Global configuration mode
dot1x max-req <count>
no dot1x max-req
dot1x re-authentication
no dot1x re-authentication
dot1x timeout quiet-period
<seconds>
no dot1x timeout quiet-period
dot1x timeout re-authperiod
<seconds>
no dot1x timeout re-authperiod
Explanation
Enable switch 802.1x address filter
function; use
disable 802.1x address filter function .
[interface
Add 802.1x address filter table item; use
the "no" command to remove 802.1x
address filter table item.
[interface
Enable switch EAP relay authentication
method; use
adopt
authentication method.
Explanation
Configure
sending EAP-request/MD5 frame when
switch
response before reload authentication;
use the "no" command to restore
default.
Configure the permission of
re-authentication for suppliant; use
the "no" command to close this function.
Configure the timeout of quiet-period for
the port; use
restore default.
Configure the timeout interval of switch
suppliant re-authentication; use
"no" command to restore default.
214
the "no" command to
the "no" command to
EAP local terminative
the maximum times
did not receive
the "no" command to
of
suppliant
the