Port Configuration Example - Accton Technology ES4626 Management Manual

Switch#show port monitor
3.2.3.5.2
If problems occur configuring port mirroring, please check the following first for
causes:
Whether the mirror destination port is a member of a trunk group or not, if yes,
modify the trunk group.
If the throughput of mirror destination port is smaller than the total throughput of
mirror source port(s), the destination port will not be able to duplicate all source
port traffic; please decrease the number of source ports or duplicate traffic of one
direction only, or choose a port with greater throughput as the destination port.

3.3 Port Configuration Example

No VLAN has been configure in the switches, the default VLAN1 is used.
Switch
SW1
SW2
SW3
The configurations are listed below:
SW1:
Switch1(Config)#interface ethernet 1/7
Switch1(Config-Ethernet1/7)# rate-limit input 150
Switch1(Config-Ethernet1/7)#rate-limit output 150
SW2:
Switch2(Config)#interface ethernet 1/9
Switch2(Config-Ethernet1/9)# speed-duplex force100-full
Switch2(Config-Ethernet1/9)#exit
Switch2(Config)#interface ethernet 1/12
Switch2(Config-Ethernet1/12)# speed-duplex force1000-full
Switch2(Config-Ethernet1/12)#port monitor interface ethernet1/8;1/9 both
Switch2(Config-Ethernet1/12)#exit
Device Mirroring Troubleshooting Help
Port
2/7
1/8
3/9
4/12
4/10
Property
Ingress bandwidth limit: 150 M
Mirror source port
100M/full, mirror source port
1000M/full, mirror destination port
100M/full
114