Accton Technology ES4626 Management Manual page 430

Area
Net type
cost
State
Type
Priority
Transit Delay
DR
BDR
Authentication key
Timer:
Hello、Poll、Dead、Retrans
Number of Neigbors
Nubmer of Adjacencies
Adjacencies
（7）show ip ospf neighbor
The "show ip ospf neighbor" command can be used to display information about the
neighbor OSPF layer3 switches.
For example, displayed information can be:
Switch#show ip ospf neighbor
interface ip 12.1.1.1
router id 12.1.1.2
state NFULL priority 1
DR 12.1.1.2 BDR 12.1.1.1
last hello 66261
interface ip 30.1.1.1
interface ip 50.1.1.1
router id 50.1.1.2
state NFULL priority 0
DR 50.1.1.1 BDR 0.0.0.0
last hello 66286
interface ip 51.1.1.1
interface ip 52.1.1.1
interface ip 100.1.1.1
interface ip 110.1.1.1
interface ip 150.1.1.1
router id 12.2.0.0
area id 0
router ip addr 12.1.1.2
last exch 65712
area id 0
area id 0
router ip addr 50.1.1.2
last exch 49614
area id 0
area id 0
area id 0
area id 0
area id 0
router ip addr 150.1.1.2
430
The area of the interface
Network type, such as broadcast, p2mp,
etc.
Cost value.
Status
Layer3 switch type, such as designated
layer3 switch.
Configure the priority in electing designated
layer3 switch.
The delay value for interface to transfer
LAS.
The designated layer3 switch.
Backup designated layer3 switch.
OSPF packet authentication key.
OSPF protocol timer: including time set for
HELLO packet, poll interval packet, route
invalid, route retransmission, etc.
The number of neighboring layer3 switches.
The number of
interfaces.
Neighboring interface IP address
neighboring route