Accton Technology ES4626 Management Manual page 453

PIM-DM in the appropriate interfaces.
Command
Interface Mode
ip pim dense-mode
no ip pim dense-mode
2. Configure PIM-DM sub-parameters
Configure PIM-DM interface parameters
a. Configure PIM-DM HELLO packet interval
Command
Interface Mode
ip pim hello-interval
<hello-interval-seconds>
no ip pim hello-interval
3. Disable PIM-DM protocol
Command
Interface Mode
no ip pim dense-mode
16.3.2.2 PIM-DM Configuration Commands
ip pim dense-mode
ip pim hello-interval
show ip pim interface
show ip pim mroute dm
show ip pim neighbor
debug ip pim
16.3.2.3 ip pim dense-mode
Command: ip pim dense-mode
no ip pim dense-mode
Function: Enable PIM-DM protocol on the interface; the "no ip pim dense-mode"
Explanation
Enable PIM-DM protocol; the "no ip pim
dense-mode" command disables PIM-DM
protocol (required)
Explanation
Set interval for sending PIM-DM HELLO
packets in the interface; the "no ip pim
query-interval" command restores the default
setting.
Explanation
Disable PIM-DM protocol
453