Accton Technology ES4626 Management Manual page 461

(1) Configure PIM-SM interface parameters
1） Configure PIM-SM HELLO packet interval
2） Configure a interface as the PIM-SM area border
(2) Configure PIM-SM global parameters
1) Configure a switch as the candidate BSR.
2) Configure a switch as the candidate RP.
3. Disable PIM-SM protocol
1. Enable PIM-SM protocol
Basic configuration of PIM-SM routing protocol on Route switch is quite simple: just
enable PIM-SM in the appropriate interfaces.
Command
Interface Mode
ip pim sparse-mode
no ip pim sparse-mode
2. Configure PIM-SM sub-parameters
1) Configure PIM-SM interface parameters
1) Configure PIM-SM HELLO packet interval
Command
Interface Mode
ip pim hello-interval
<hello-interval-seconds>
no ip pim hello-interval
2) Configure the interface as the PIM-SM BSR border
Command
Interface Mode
ip pim bsr-border
no ip pim bsr-border
2) Configure PIM-SM global parameters
1) Configure a switch as the candidate BSR.
Command
Interface Mode
Explanation
Enable PIM-SM protocol; the "no ip pim sparse-mode"
command disables PIM-SM protocol (required)
Explanation
Set interval for sending PIM-SM HELLO
packets in the interface; the "no ip pim
query-interval" command restores the default
setting.
Explanation
Set the interface as the PIM-SM BSR border;
the "no ip pim bsr-border" command cancels
the setting of BSR border.
Explanation
461