Function: Display information for the PIM interface.
Parameter: <ifname> is the interface name, i.e. display PIM information of the specified
interface.
Default: PIM information is displayed by default on all interfaces.
Command mode: Admin Mode
Example: Display PIM information of interface vlan 1.
Switch#sh ip pim interface vlan 1
Interface Vlan1 : 2.1.1.2
owner is pimdm, Vif is 1, Hello Interval is 30
Neighbor-Address Interface
2.1.1.1
Vlan1
Switch#
Displayed information
Interface (the former)
Owner
Vif
Hello Interval
Neighbor-Address
Interface (the latter)
Uptime
Expires
16.3.4.1.4
debug ip pim
Command: debug ip pim
Function: Enable the debug function for displaying detailed PIM information; the "no"
format of this command disables this debug function.
Parameter: N/A.
Default: Disabled.
Command mode: Admin Mode
Usage Guide: If detailed information about PIM packets etc is required, this debug
command can be used.
Example:
Switch # debug ip pim
00: 15: 45: PIM: Send v2 Hello on vlan1, holdtime 105
00: 15: 45: PIM: Send v2 Hello on vlan1, holdtime 105
00: 15: 45: PIM: Received v2 Hello on vlan1 from 2.1.1.2, holdtime 105
Uptime
00: 26: 23
Explanation
Interface name and interface IP.
Multicast routing protocol of the interface.
Corresponding virtual interface index to the interface.
The HELLO packet interval configured on the interface (in seconds)
Neighbor address
The neighbor interface discovered.
The up time of the neighbor since discovery.
The remaining time before considering the neighbor to be invalid.
458
Expires
00: 01: 39