Accton Technology ES4626 Management Manual page 222

8.2.2.15 dot1x timeout re-authperiod
Command: dot1x timeout re-authperiod <seconds>
no dot1x timeout re-authperiod
Function: Configure switch re-authenticate time interval to supplicant; use the "no"
command to restore default.
Parameter: <seconds>re-authenticate time interval, unit is second, The range: 1~65535.
Command mode: global configuration mode
Default: Default is 3600 seconds.
Instructions: When modify switch re-authenticate time interval to supplicant, must enable
dot1x re-authentication first. If did not configure switch re-authenticate function, the
configured time interval of switch re-authenticate to supplicant will not be effective.
Example: Configure re-authentication time as 1200 seconds.
Switch(Config)#dot1x timeout re-authperiod 1200
8.2.2.16 dot1x timeout tx-period
Command: dot1x timeout tx-period <seconds>
no dot1x timeout tx-period
Function: Configure the time interval which of switch retransmit EAP-request/identity
frame to suppliant; use the "no" command to restore default.
Parameter: <seconds>is the time interval of retransmit EAP request frame, unit is
second, The range: 1~65535.
Command mode: global configuration mode
Default: Default is 30 seconds.
Instructions: suggest using default value.
Example: Modify the retransmit EAP request frame time interval as 1200 seconds.
Switch(Config)#dot1x timeout tx-period 1200
8.2.2.17 radius-server accounting host
Command: radius-server accounting host <ip-address> [port <port-number>]
[primary]no radius-server accounting host <ip-address>
Function: Configure RADIUS accounting server IP address and monitor port ID; use
the "no" command to remove RADIUS accounting server .
Parameter: <ip-address> server IP address; <port-number> is server monitor port ID,
The range: 0~65535; primary is primary server, when configure RADIUS server, may
configure many servers, when not configure primary, finding usable RADIUS server
222