Web Management; Lacp Port Group Configuration - Accton Technology ES4626 Management Manual

otherwise LACP packet wouldn't be initialed.
LACP cannot be used on port enabled Security and 802.1x, therefore it cannot be
enabled if those two protocols are present on the port.
Port Channel Configuration

10.5 Web Management

Click Port Channel configuration. LACP port group configuration node and LACP port
configuration node are shown. LACP port group page is used to configure and show
goupe; LACP port page is used to configure and show group member ports.
10.5.1

LACP port group configuration

Click LACP port group configuration. The configuration page is shown. See the equivalent
CLI command at 10.2.2.1
The explanation of each field is as below:
Group Num - group number
Load balance mode - Load balance mode: src-mac, dst-mac, dst-src-mac, src-ip, dst-ip
and dst-src-ip
Operation type - Add port group or Remove port group
For example: Set group Num to 1; set Load balance mode to src-mac; set Operation type
to Add port group, and then click Apply.
After LACP port group is configured, the configuration is shown below.
The explanation of each field is as below:
port group - Port group
load balance - Load balance mode
270