Command
Admin Mode
rcommand member <mem-id>
rcommand commander
cluster reset member<mem-id>
cluster update member <mem-id> <src-url>
<dst-url> [ascii | binary]
18.2.2
Cluster Configuration Commands
18.2.2.1 cluster run
Command: cluster run
no cluster run
Function: Enable cluster function; the "no cluster run" command disables cluster
function.
Command mode: Global Mode
Default: Cluster function is disabled by default.
Usage Guide: This command enables cluster function. Cluster function has to be enabled
before implementing any other cluster commands. The "no cluster run"
disables cluster function.
Example: Disable cluster function in the local switch.
Switch (Config)#no cluster run
18.2.2.2 cluster register timer
Command: cluster register timer<time-value>
no cluster register timer
Explanation
In the commander switch, this
command is used to configure and
manage member switches.
In
the
member
command is used to configure the
member switch itself.
In the commander switch, this
command is used to reset the
member switch.
In the commander switch, this
command is used to remotely
upgrade the member switch.
517
switch,
this