Lacp Port Configuration - Accton Technology ES4626 Management Manual

10.5.2

LACP port configuration

Click LACP port configuration. The configuration page is shown. See the equivalent CLI
command at 10.2.2.2
The explanation of each field is as below:
group num - Group number
Port - Specify the port
Port mode - Configure port mode: active, passive or on
Operation type - Add port to group or Remove port from group
For example: Set group num to 1; set Port to Ethernet 1/1; set Port mode to active; set
Operation type to Add port to group, and then click Apply.
Show member port
After LACP port is configured, the configuration is shown below. See the equivalent CLI
command at 10.4.1.1
The explanation of each field is as below:
Port - Member port name
Port mode - active, passive or on
271