Accton Technology ES4626 Management Manual page 394

ip ospf enable area <area_id>
no ip ospf enable area
2. Configure OSPF sub-parameters
(1) Configure OSPF packet sending mechanism parameters
a. Configure OSPF packet verification
b. Set the OSPF interface to receive only
c. Configure the cost for sending packets from the interface
Command
Interface Mode
ip ospf authentication { simple
<auth_key>| md5
<key_id>}
no ip ospf authentication
[no] ip ospf passive-interface
ip ospf cost <cost >
no ip ospf cost
d. Configure OSPF packet sending timer parameter (timer of broadcast interface
sending HELLO packet to poll, timer of neighboring layer3 switch invalid timeout, timer of
LSA transmission delay and timer of LSA retransmission.
Command
Interface Mode
ip ospf hello-interval <time>
no ip ospf hello-interval
ip ospf dead-interval <time >
no ip ospf dead-interval
ip ospf transmit-delay <time>
no ip ospf transmit-delay
ip ospf retransmit <time>
no ip ospf retransmit
(2) Configure OSPF route introduction parameters
a. Configure default parameters (default type, default tag value, default cost, default
interval and default number uplimit)
Command
OSPF protocol configuration mode
default redistribute type { 1 | 2 }
no default redistribute type
Sets an area for the specified interface; the
"no ip ospf enable area" command cancels
the setting. (required)
Explanation
Configures the authentication method and key
required by the interface to accept OSPF
<auth_key>
packets; the "no ip ospf authentication"
command restores the default setting.
Sets an interface to receive only, the "no ip
ospf passive-interface" command cancels
the setting.
Sets the cost for running OSPF on the
interface; the "no ip ospf cost" command
restores the default setting.
Explanation
Sets interval for sending HELLO packets; the
"no ip ospf hello-interval" command restores
the default setting.
This line should be deleted.
Sets the interval before regarding a neighbor
layer3 switch invalid; the "no ip ospf
dead-interval" command restores the default
setting.
Sets the delay time before sending link-state
broadcast; the "no ip ospf transmit-delay"
command restores the default setting.
Sets the
link-state
layer3 switches; the "no ip ospf retransmit"
command restores the default setting.
Explanation
Sets the default route weight for route to be
introduced; the "no default-metric" command
restores the default setting.
394
interval for retransmission
advertisement among
of
neighbor