Accton Technology ES4626 Management Manual page 374

router rip
timer basic
version
show ip protocols
show ip rip
debug ip rip packet
debug ip rip recv
debug ip rip send
15.3.2.2.1 auto-summary
Command: auto-summary
no auto-summary
Function: Configure route aggregation; the "no auto-summary" command disables
route aggregation.
Parameter: N/A.
Default: Auto route aggregation is not used by default.
Command mode: RIP configuration mode
Usage Guide: Route aggregation reduces the amount of routing information in the route
table and amount of information to be exchanged. RIP-I does not support subnet mask,
forwarding subnet route may result in ambiguity. For this reason, route aggregation is
always enabled for RIP-I. If you are using RIP-II, you can use "no auto-summary"
command to disable route aggregation. If subnet route needs to be broadcasted, route
aggregation can also be disabled.
Example: Set the RIP version to RIP-II and disables route aggregation.
Switch(Config)#router rip
Switch(Config-Router-Rip)#version 2
Switch(Config-Router-Rip)#no auto-summary
Related command: version
15.3.2.2.2 default-metric
Command: default-metric <value>
no default-metric
Function: Set the default route metric for route to be introduced; the "no default-metric"
command restores the default setting.
Parameter: < value> is the value of route metric, ranging from 1 to 16.
Default: The default route metric is 1.
Command mode: RIP configuration mode
Usage Guide: "default-metric" command sets the default route metric used in
374