Displaying Details For Remote Meps - Edge-Core ECS3510-10PD Management Manual

| Basic Administration Protocols
C 14
HAPTER
Connectivity Fault Management
D D
ISPLAYING ETAILS
R MEP
FOR EMOTE S
P
ARAMETERS
These parameters are displayed:
MEP ID – Maintenance end point identifier.
◆
MA Name – Maintenance association name.
◆
Level – Authorized maintenance level for this domain.
◆
◆ Primary VLAN – Service VLAN ID.
MEP Up – Indicates whether or not this MEP is functioning normally.
◆
Remote MAC Address – MAC address of the remote maintenance
◆
point. (If a CCM for the specified remote MEP has never been received
or the remote MEP record times out, the address will be set to the initial
value of all Fs.)
W I
EB NTERFACE
To show information for remote MEPs:
Click Administration, CFM.
1.
Select Show Information from the Step list.
2.
Select Show Remote MEP from the Action list.
3.
Figure 314: Showing Information on Remote MEPs
Use the Administration > CFM > Show Information (Show Remote MEP
Details) page to show detailed information for MEPs located on other
devices which have been discovered through continuity check messages, or
statically configured in the MEP database and verified through cross-check
messages.
CLI R
EFERENCES
"show ethernet cfm maintenance-points remote detail" on page 1345
◆
P
ARAMETERS
These parameters are displayed:
MD Index – Domain index. (Range: 1-65535)
◆
– 552 –