Replacing The Drive Axle; Replacing A Clamp Block Of The Axle Retainer - Otto Bock Voyager Evo Service Manual

3.10.2 Replacing the Drive Axle

INFORMATION
To replace the drive axle with a larger or smaller rear wheel axle, the seat plate, back plate, stabiliser and tube
footrest also have to be replaced.
1) Loosen the Allen head screws of the clamp brackets on both sides (see Fig. 61).
2) Remove the clamp brackets (see Fig. 62).
3) Loosen the Allen head screws of the clamp blocks on both sides (see Fig. 63).
4) Replace the drive axle (see Fig. 64).
5) Tighten the Allen head screws of the clamp blocks on both sides to 15 Nm (see Fig. 63).
6) Mount the clamp brackets (see Fig. 62).
7) Tighten the Allen head screws of the clamp brackets on both sides to max. 7 Nm (see Fig. 61).

3.10.2.1 Replacing a Clamp Block of the Axle Retainer

1) Loosen the Allen head screw of the clamp bracket (see Fig. 65).
2) Replace the clamp block (see Fig. 66).
3) Tighten the Allen head screw of the clamp bracket to max. 7 Nm (see Fig. 65).
Voyager evo
61
63
Service Work
62
64
Ottobock | 25