Replacing The Oscillating Crank - Otto Bock Xeno Service Manual

1
Figure 74 Replacing the drive motor
1 Allen head screws
6.14 Replacing the Oscillating Crank
INFORMATION
When attaching the motors to the oscillating cranks, be sure to tighten the bottom screws first.
Each motor is attached to the oscillating cranks with 4 Allen head screws. The oscillating cranks
are attached to the drive unit sustainer with one screw each.
Preparation:
❒ Loosen the brake release (see Section 6.6.1).
❒ Remove the drive motor (see Section 6.11).
Tools:
❒ Socket, size 19
❒ Allen wrench, size 6 mm
Steps:
1. Loosen the Allen head screw.
2. Remove the oscillating crank and replace if required.
Properly reassemble all components upon completion of the work.
70