Adjusting The Standard Seat; Adjusting The Side Panels; Adjusting The Back Support Upholstery - Otto Bock C1000 DS Instructions For Use Manual

Preparing the product for use
CAUTION
Wearing of unsuitable work clothing
Chemical burns due to insufficient protection
► Wear suitable work clothing (for example, gloves and protective eyewear) when working on the batteries.
NOTICE
Use of unsuitable packaging
Damage to the product caused by transportation using incorrect packaging
► Use only the original packaging for delivery of the product.

6.3.1.2 Adjusting the standard seat

6.3.1.2.1 Adjusting the side panels

INFORMATION
Additional information regarding adjustment of the arm support height and forearm length: see Page 20.
3

6.3.1.2.2 Adjusting the back support upholstery

INFORMATION
A well-adjusted back support provides lasting comfort for the wheelchair user and reduces the risk of secondary
damage and pressure zones.
INFORMATION
Ensure that the user's pelvis is positioned as far back in the seat as possible, i.e. between the back support
tubes.
The adjustable back support upholstery can be adjusted in segments to the needs of the user. In order to properly
adjust the upholstery, the user must be sitting in the wheelchair during the adjustment process.
4
16
Adjusting the side panel width
1) Remove the seat plate. Do this by reaching under
the seat plate from behind and pushing it up and off
the seat frame (see fig. 3, item 1).
2) Loosen the mounting screws on the seat frame (see
fig. 3, item 2).
3) Slide the side panel mounting to the desired posi­
tion (see fig. 3, item 3).
4) Tighten the mounting screws to 10 Nm (see fig. 3,
item 2).
5) Engage the seat plate on the seat frame at the front
and push it down onto the seat plate at the back
(see fig. 3, item 1).
Adjusting the back support upholstery
1) Pull the fabric of the back support pad off the hook-
and-loop straps of the back support upholstery and
fold it up.
2) Open and loosen the hook-and-loop straps one
after the other (see fig. 4).
C1000 DS