Adjusting The Back Support; Adjusting The Back Support Height; Adjusting The Seat; Adjusting The Seat Depth - Otto Bock Start Multi Instructions For Use Manual

Adjustments by qualified personnel

7.5 Adjusting the back support

7.5.1 Adjusting the back support height

1) Remove the back support pad (see page 34).
2) Remove the hexagon socket screws on the back plate (see fig. 24, item 1).
3) Move the back plate to the desired height (see fig. 24, item 2).
4) Attach the back plate. Tighten the hexagon socket screws to 6 Nm.
5) Press the back support pad onto the back plate and secure it against sliding.
24

7.6 Adjusting the seat

7.6.1 Adjusting the seat depth

1) Remove the seat cushion (see page 36).
2) Remove the hexagon socket screws on the seat plate (see fig. 25, item 1).
3) Move the seat plate to the desired depth (see fig. 25, item 2).
4) Attach the seat plate. Tighten the hexagon socket screws to 6 Nm.
5) Adjust the depth of the leg supports (see page 23).
6) Fit the seat cushion.
25

7.6.2 Adjusting the seat width

The seat width is adjusted via the distance between the side panels.
The delivery condition of the seat width for size S = 390 mm, M = 440 mm, L = 490 mm. The seat width can be
additionally increased by 60 mm in any size.
Adjusting the distance of the side panels
1) Remove the leg supports (see page 36).
2) Loosen the hexagon socket screws underneath the side panel attachment device on the seat frame (see fig. 26,
item 1).
3) Depending on the desired seat width, slide the side panels inwards or outwards (see fig. 27, item 2).
4) Tighten the hexagon socket screws on the side panel mounting to 6 Nm.
5) Install the leg supports.
22 Start Multi