Fig. 25 Charging Receptacle - Otto Bock C1000 Instructions For Use Manual

Operation
Protect the battery charger from direct sunlight to
❒
prevent the charger from getting any warmer than it
already is.
The place where the battery charger will be used
❒
must be dry and well ventilated. Avoid letting dust
and dirt enter and affect the function of the battery
charger.
To clean the charger, use a dry piece of cloth.
❒
DAngEr!
Explosion hazard as a result of sparks!
Always switch off the battery charger and
remove the mains plug before disconnecting
the battery.
To charge the batteries, proceed as follows:
1. Turn off the control on the power wheelchair.
2. Open the charging receptacle cover; the charging
receptacle is integrated in the left or right lateral
covering (see fig. 25).
Page 116
fig. 25 charging receptacle
1 Charging receptacle
2 Plug of the battery charger
3 Cover
3. Connect the plug of the battery charger to the
charging receptacle on the power wheelchair.
4. Connect the battery charger to a wall socket and
turn it on. The batteries will start charging automati-
cally, and the current charge status is indicated on
the LEDs of the battery charger (see table 2).
5. When the charging process is complete, turn off the
battery charger:
Disconnect the battery charger from the mains
supply, then from power wheelchair.
12/2009 C1000