Batteries/Charging Process; Safety Instructions; General - Otto Bock C1000 SF Instructions For Use Manual

17
Brake deactivated: warning on control panel/LCD monitor
Display

6.10 Batteries/charging process

6.10.1 Safety instructions

CAUTION
Failure to check the charge level before putting into operation
Injury to the user due to stopping suddenly, problems due to unplanned stalling
► Check the charge level of the batteries before each use.
► Always make sure that the charge level of the batteries is sufficient for the planned distance.
► Never drive with the batteries almost fully discharged.
► When the batteries are almost fully discharged, charge them promptly.
NOTICE
Unauthorised battery replacement
Battery damage due to unauthorised changes to the product
► Replacing the battery or modifying the battery installation position may only be performed by qualified person­
nel trained by the manufacturer.
► The charging profile of the battery charger established at the factory matches the batteries included in the
scope of delivery and may not be altered independently.

6.10.2 General

The power wheelchair is equipped with maintenance-free batteries. See the section "Technical data" for the battery
capacity.
The batteries are located in a battery case under the seat of the power wheelchair.
Prolonged driving when the battery is low results in deep discharge and battery damage. If the power wheelchair is
being driven when the battery is low the control unit switches to creep speed to save power.
C1000 SF
Information
Brake released (control panel)
Brake released (LCD monitor)
Releasing/deactivating the brake
1) If needed: Turn the control device off.
2) Push the brake release levers down (see fig. 17,
see arrow).
→ The drive motors are released and the power wheel­
chair has no braking function.
→ After switching the control device on: The control
device recognises that the brake has been released
and deactivates the driving function.
→ A warning will appear on the control panel when the
joystick is deflected (see below).
Enabling/activating the brake
1) If needed: Turn the control device off.
2) Push the brake release lever up (see fig. 17, see
arrow).
3) Switch on the control device.
→ The driving function is activated.
Use
31