NUDA 900 2012/2013 - NUDA 900 R 2012/2013
2
3
4
1
GENERAL ENGINE PROCEDURES
FLYWHEEL AND STARTER MOTOR IDLE GEAR REMOVAL
-
Remove the right crankcase and fix the engine at the top dead centre, as
described in the relevant paragraphs.
-
Remove the screw (1) with the washer.
-
Heat the flywheel hub (2) to a temperature of approx. 100°C.
1
-
Remove the flywheel together with the freewheel (2) using a suitable puller.
-
Check the tab and replace it if necessary.
H10230
Removal/installation of the freewheel from/on the flywheel
2
Removal:
-
Unscrew the screws (3) and remove the flange (4) and the freewheel (5) from
the flywheel (2).
5
Installation:
-
Check the condition of the freewheel (5), and replace it if it is ruined.
-
Refit the freewheel (5) with the relevant flange, tightening the screws to torque
(3).
H10444
Freewheel control gear removal
-
Remove the freewheel control gear (1).
H10451
F1.9
Workshop Manual Ed. 11-2011