Husqvarna NUDA 900 R 2012 Workshop Manual page 256

4
5
Workshop Manual Ed. 11-2011
NUDA 900 2012 - NUDA 900 R 2012
-
3
-
-
-
-
H10860
BRAKES
Remove the cover (3) of the fluid reservoir (4), the rubber gaiter and fill the
reservoir with fresh fluid.
Pull the lever (5) of the brake and keep it pulled so that the system remains
under pressure, loosen the valve (2), tighten the valve (2) always with the
lever pulled, then release the lever.
Top up the fluid level (4), wait a few seconds, then repeat a few times the
procedure described in the line above until the liquid comes out of the trans-
parent hose without bubbles.
Lock the bleed valves to the specified torques.
Top up the fluid level and refit the rubber gaiter and the cover (3) of the res-
ervoir (4).
Fluid level inside the reservoir shall never drop below the minimum
notch during the bleeding procedure.
Brake fluid is corrosive. In the event of contact with eyes, rinse with
abundant water.
Motorcycle handlebar must be turned to the left during the bleed-
ing procedure. This will keep the master cylinder reservoir higher,
making bleeding easier.
If brake lever or brake pedal feel mushy after a fall or after a repair,
resulting in loss of braking, bleed the circuit as described above.
L.16