Crankshaft Removal; Compensation Arm Removal; Connecting Rod Cap Removal - Husqvarna NUDA 900 R 2012 Workshop Manual

NUDA 900 2012/2013 - NUDA 900 R 2012/2013
4
1
4
3
1
1
Workshop Manual Ed. 11-2011
CRANKCASE DISASSEMBLY
Installation:
- Heat the drum in the area of the internal bearing to approx. 80°C.
- Fit the inner bearing (4) using a press, making sure that the bearing rests
correctly on its seat.
- The external edge of the bearing (4) mush be flush with the external edge of
the drum.
H10375
- Heat the external bearing (1) to approx. 80°C.
- Fit the external bearing (1) on the drum, making sure that the bearing rests
correctly on the relevant drum seat.
H10376

CRANKSHAFT REMOVAL

Compensation arm removal

- Move the compensation arm backwards and remove the screws (1).
- Remove the connecting rod caps (2) and the balancing connecting rod (4).
The connecting rod and the compensation arm must not be disas-
sembled.
- Remove the split bearings (3).
3
2
H10377

Connecting rod cap removal

- Mark the connecting rod caps for the respective connecting rods.
- The marks must face the direction of travel.
- Support the lower part of the pistons.
- Remove the connecting rod bearing screws (1) and remove the two caps (2).
2
H10378
F3.10