Husqvarna NUDA 900 R 2012 Workshop Manual page 136

NUDA 900 2012/2013 - NUDA 900 R 2012/2013
13
14
18
13
17
19
Workshop Manual Ed. 11-2011
GENERAL ENGINE PROCEDURES
- Remove the control gear (13).
H10276
- Check that the hole (14) in the engine cylinder head is not blocked and clean
it if necessary.
- Clean the seat of the pump in the engine cylinder head.
H10277
- Lubricate the washers (15), the bearing (16) and the pin (17) with engine oil.
- Lubricate the pump shaft through the hole (18) with engine oil.
- Make sure the control gear (13) is correctly positioned on the shaft.
- The pin (17) must engage in the control gear (13).
16
15
H10278
- Seal the pump support surface (19) using Three-Bond 1209 sealant.
- Lubricate the sealing rings (20) with KLUEBER 46 MR 401 (replace them if
H10279
F1.22