Oil Sump Removal/Installation; Mesh Oil Filter Replacement - Husqvarna NUDA 900 R 2012 Workshop Manual

NUDA 900 2012/2013 - NUDA 900 R 2012/2013
1
2
4
4
1
2
3
4
4
Workshop Manual Ed. 11-2011
GENERAL ENGINE PROCEDURES

OIL SUMP REMOVAL/INSTALLATION

Removal:
- Drain the oil from the engine as described in the relevant paragraph.
- Remove the screws (1) and the oil sump (2).
Installation:
- Clean the sealing surfaces.
- Fit the oil sump (2) paying attention to the centring pins.
- Tighten the screws (1) to torque as described in the installation sequence
(1) - (14).
7
H10429
8
9
1
10
11

MESH OIL FILTER REPLACEMENT

- Disassemble the oil sump as described in the relevant paragraph.
4
Removal:
- Release the oil manifold prongs (3) from the retainers (4).
- Remove the manifold (3), the gasket (2) and the mesh filter (1).
- Clean or replace the mesh filter (1).
4
H10298
Installation:
4
- Check the oil manifold gasket (2) and replace it if necessary.
- The manifold must be precisely inserted in the cover of the swing arm hous-
ing, as any leaks cause a reduction in oil delivery.
- Check the prongs on the manifold (3), and if damaged or broken replace the
manifold.
4 - Fit the filter (1) on the manifold (3), paying attention to the installation position.
- The circular rib (arrow) on the filter must face towards the engine.
1
- Fit the oil manifold (3) with the gasket (2) on the engine, making sure all
prongs engage in the support (4).
2
- Refit the oil sump as described in the relevant paragraph.
3
H10299
F1.26
4
9 8
3
2
14
13
12
H10430