Rear Braking System - Husqvarna NUDA 900 R 2012 Workshop Manual

4
5
2
Workshop Manual Ed. 11-2011
NUDA 900 2012 - NUDA 900 R 2012
- Remove the cover (3) with the respective gaiter of the oil reservoir (4).
- Pull the lever (5) of the brake and keep it pulled, loosen the valve (2) and
3
wait for the oil to come out, then tighten the valve (2) and release the lever
(5).
- Repeat this procedure a few times both for the left and the right calliper, until
the oil is completely drained.
- Fill the reservoir (4) with the new fluid.
- Pull the lever (5) of the brake and keep it pulled so that the system remains
under pressure, loosen the valve (2), tighten the valve (2) always with the
lever pulled, then release the lever.
- Top up the fluid level (4) and repeat a few times the procedure described in
the line above until the system is completely full and the clear fluid begins to
come out without bubbles from the transparent hose.
- Repeat the same procedures for the other calliper.
- Top up the fluid level (4) and refit the cover (3) with the gaiter.
H10860

Rear braking system

- Remove the rubber cap (1) of the valve (2) of the calliper.
- Insert the end of a transparent hose in the valve (2); insert the other end in
a container.
- Remove the cover (3) with the respective gaiter of the oil reservoir (4).
- Press on the brake pedal (5) and hold it pressed, loosen the valve (2) and
wait for the oil to come out, then tighten the valve (2) and release the pedal
(5).
- Repeat this procedure a few times until the oil is completely drained.
1 - Fill the reservoir (4) with new liquid.
- Press on the brake pedal (5) and hold it pressed so that the system is under
pressure, loosen the valve (2), tighten the valve (2) always with the pedal
pressed, then release the pedal.
- Top up the fluid level (4) and repeat a few times the procedure described in
the line above until the system is completely full and the clear fluid begins to
come out without bubbles from the transparent hose.
- Top up the fluid level (4) and refit the cover (3) with the gaiter.
H10872
3
4
H10873
BRAKES
After replacing the fluid, bleed the system on both callipers and on
the master cylinder as described in the relevant paragraph.
After replacing the fluid, bleed the system as described in the rel-
evant paragraph.
L.14
5
H10874