Clutch Pressure Plate Disassembly - Husqvarna NUDA 900 R 2012 Workshop Manual

NUDA 900 2012/2013 - NUDA 900 R 2012/2013
5
4
1
3
2
1
2
2
1
GENERAL ENGINE PROCEDURES
- Insert the actuator pin (4) in the pressure plate (5) and fit the pressure plate
(5).
- Insert the flanged bushings (2) on the springs (3) and fit the springs on the
pressure plate (5).
- Tighten the screws (1) to torque in a diametrically opposite order.
Refit the other parts that were previously removed as described in the relevant
paragraph.
H10257

Clutch pressure plate disassembly

- Disassemble the pressure plate (1) as described in the paragraph "Clutch
disassembly".
H10258
- Position the pressure plate with the upper side facing downwards.
- Heat the pressure plate to approx. 80°C.
- Remove the disengagement bearing (2) using a suitable puller.
- Clean the housing of the support.
- Lubricate the clutch disengagement bearing with engine oil.
- Heat the pressure plate to approx. 80°C.
H10259
- Fit the clutch disengagement bearing (2) using a suitable tool.
The writing on the bearing must face towards the engine (visible
during installation).
- Refit the pressure plate (1) as described in the paragraph "Clutch disas-
sembly".
H10260
F1.17
Workshop Manual Ed. 11-2011