NUDA 900 2012/2013 - NUDA 900 R 2012/2013
3
4
5
3
4
5
GENERAL ENGINE PROCEDURES
SWING ARM COVER REMOVAL/INSTALLATION
Removal:
-
Disassemble the oil sump as described in the relevant paragraph.
1
-
Remove the screws (1) and the gasket (2).
2
H10431
-
Remove the screws (3).
-
Remove the cover (4).
-
Remove the gasket (5).
H10293
Installation:
-
Clean the threading and the sealing surfaces.
6
The pin of the compensation connecting rod axis could detach.
During installation, make sure that the pin of the compensation
connecting rod axis is correctly fixed in its seat.
-
Check the correct positioning of the pin (6).
-
Fit the gasket (5) and the cover (4) on the crankcase.
-
Manually tighten the screws (3) (Loctite 243).
H10294
-
Fit the gasket (2) and manually tighten the screws (1) (Loctite 243).
1
2
H10431
F1.27
Workshop Manual Ed. 11-2011