Rear Brake Fluid Level Check; Oil Level Check - Husqvarna NUDA 900 R 2012 Workshop Manual

NUDA 900 2012/2013 - NUDA 900 R 2012/2013
MAX
1
2
3
Workshop Manual Ed. 11-2011
SETTINGS AND ADJUSTMENTS

Rear brake fluid level check

The fluid level in the master cylinder tank shall never be below the minimum level
(1) shown on the transparent reservoir (2).
A decrease in the fluid level will let air into the system and increase the lever
2
stroke.
If the brake pedal feels mushy when pulled, there may be air in the
brake lines or the brake may be defective.
Do not spill brake fluid onto any painted surface or light lens.
1
MIN
H10684
Do not mix two brands of fluid. Completely change the brake fluid
in the brake system if you wish to switch to another fluid brand.
Brake fluid may cause irritation. Avoid contact with skin or eyes.
In case of contact, flush thoroughly with water and call a doctor if
your eyes were exposed.

Oil level check

- Start vehicle as described in the relevant section, let it run for approx. 3 min-
utes so as to warm engine up.
- Stop the engine.
- Keeping the motorbike upright and on even ground, wait a few minutes for
MAX
the oil to reach the sump.
- Check the level as follows:
MIN
- Undo the cap (1) with the dipstick (2) and remove it from the engine.
- Clean the dipstick (2) with a cloth.
- Place the dipstick (2) in the hole (3) without screwing the cap on.
- Remove the dipstick (2) from the hole (3) and check that the level is
between the two MIN and MAX marks.
- To top up, pour oil into the hole (3); for the type of oil, see the section "Techni-
cal data".
H10685
D.10