Fuel Pump Removal - Husqvarna NUDA 900 R 2012 Workshop Manual

NUDA 900 2012/2013 - NUDA 900 R 2012/2013
2
5
Workshop Manual Ed. 11-2011
GENERAL PROCEDURES

Fuel pump removal

- Disassemble the saddle as described in the relevant paragraph.
- Disconnect the connector (1).
- Disconnect the fuel pipe (2) by loosening the two screws; collect the fuel that
could come out.
1
H10775
- Use a suitable tool to loosen the ring nut (3) and remove the reservoir pump
3
(4).
H10776
1
5
- Check the seal (5) for wear, change it if dry or damaged.
During the reassembly, make sure that the seal is in the correct
position: the lip with the greater diameter must be installed facing
outwards.
- Check the status of the O-ring seals, replace if damaged.
C
H10778
MAX
- During the reassembly of the pump the reference tab (6) on the pump (4)
4
should coincide with the seat (7) in the reservoir ring nut.
MIN
- Reinstall the ring nut (3) and tighten it with a suitable tool.
6
7
H10777
E.22
1
1
1
2
1