GENERAL ENGINE PROCEDURES
NUDA 900 2012/2013 - NUDA 900 R 2012/2013
1
1
2
1
2
3
Clutch disengagement shaft oil seal installation
-
Lubricate the oil seal lip (1) with engine oil.
-
Install the shaft oil seal (1) with the thrust spindle.
-
The open side of the sealing ring is located inside.
H10213
Clutch disengagement shaft upper bearing removal
-
Protect the cover with adhesive tape.
-
Fit the specific puller, making sure that the jaws engage in the slit between
the bearing and the cover.
-
Remove the bearing.
H10216
Installation of both clutch disengagement shaft bearings
-
Lightly lubricate both bearings with engine oil.
-
Install the needle roller bearings (1) and (2).
-
Drive the upper needle roller bearing (2) until it is flush with the sealing ring
housing, using a suitable tool.
H10217
Disengagement shaft installation
-
Lubricate the clutch disengagement shaft with engine oil.
-
Insert the clutch disengagement shaft (2), being careful not to damage the
sealing ring.
-
Push the spring (3) onto the clutch disengagement shaft and press the shaft
down, paying attention to the installation position of the spring.
-
Install the retaining ring (1).
-
Turn the shaft and check that the spring is hooked.
H10214
F1.5
Workshop Manual Ed. 11-2011