Front Braking System Removal - Husqvarna NUDA 900 R 2012 Workshop Manual

1
4
5
7
9
Workshop Manual Ed. 11-2011
NUDA 900 2012 - NUDA 900 R 2012

Front braking system removal

To remove the front braking system from the vehicle, you must separate the var-
ious components; then you should empty the liquid from the system as follows:
2
- Remove the rubber cap (1) of the coupling (2) of one of the two callipers.
- Insert a transparent hose in the coupling and the other end of the hose in a
container.
- Remove the cover (3) with the respective gaiter of the oil reservoir (4).
- Pull the brake lever (5) and keep it pulled, loosen the coupling (2) and wait
for the oil to come out, then tighten the coupling (2) and release the lever (5).
- Repeat this procedure a few times both for the left and the right calliper, until
the oil is completely drained.
H10859
- Loosen the couplings (6) and detach the pipes (7).
3
- Loosen the screws (8) and remove the callipers (9) making sure to collect the
liquid that could remain inside pipe.
H10860
6
8
H10861
BRAKES
Do not spill brake fluid onto any painted surface or lens (for example
lights lens).
Do not mix two brands of fluid. Completely change the brake fluid
in the brake system if you wish to switch to another fluid brand.
Brake fluid may cause irritation. Avoid contact with skin or eyes.
In case of contact, flush thoroughly with water and call a doctor if
your eyes were exposed.
6
9
L.8
7
8
H10862