Oil Pump; Oil Suction Pump Removal/Installation - Husqvarna NUDA 900 R 2012 Workshop Manual

NUDA 900 2012/2013 - NUDA 900 R 2012/2013
3
1
3
2
1
3
2
5
3
Workshop Manual Ed. 11-2011
GENERAL ENGINE PROCEDURES

OIL PUMP

Oil suction pump removal/installation

2
Removal:
1
- Remove the sprocket casing as described in the relevant paragraph.
- Remove the screws (1).
- Disassemble the cover (2) with the gasket (3).
H10261
- Disassemble the rotor (2) with the rotating piston (1), extract the pin (3) from
the shaft.
- Check the condition of the pin (3) and replace it if necessary.
H10262
Installation:
- Clean all components prior to installation and lubricate them with engine oil.
- Insert the pin (3) in the shaft.
- Place the rotating piston (1) on the shaft with the mark (4) facing outwards,
4
paying attention to the correct positioning of the pin (3).
- Fit the rotor (2) with the mark (5) facing outwards, so that it coincides with
the mark (4) on the rotating piston (1).
H10263
- Clean the sealing surfaces.
- Lightly lubricate the new gasket (3) with engine oil and place it on the cover
(2).
2
- Fit the cover (2) tightening the screws (1) to torque.
1
- Refit the other parts as described in the relevant paragraphs.
H10264
F1.18