Husqvarna NUDA 900 R 2012 Workshop Manual page 273

NUDA 900 2013 - NUDA 900 R 2013
1
2
3
5
4
BRAKES
REPLACEMENT FRONT BRAKE PADS NUDA 900
- Loosen the two screws (1) and remove the calliper (2).
H10868
- Remove the two safety clips (3).
- Slide out the two pins (4) and remove the metal sheet (5).
- Replace the brake pads (6).
Do not use the brake lever while removing the pads.
NOTE: Refit the metal sheet (5) so that the arrow points in the direction
of rotation of the brake disc.
- Refit the pins and the safety pins.
- Refit the calliper tightening the screws (1) to the specified torque.
NOTE: During the reassembly of the callipers, first of all insert the retain-
H10869
ing screws manually then, before tightening them to the specified
torque, keep the lever of the front brake pulled, for instance with
an elastic. Only at this point, tighten the retaining screws of the
callipers to the specified torque.
This ensures the correct positioning between the brake disc and
the body of the calliper, avoiding thus that the pistons work incor-
rectly.
Acting as described above, after replacing the pads it is not necessary to bleed
the system, just act the control lever several time until the pistons get in the
normal position.
H10870
L1.15
6
H10871
Workshop Manual Ed. 11-2011