Rear Pads Disassembly; Rear Pads Assembly; Checking Brake Pads For Wear / Replacing The Pads - Husqvarna NUDA 900 R 2012 Workshop Manual

A
1
2
Workshop Manual Ed. 11-2011
NUDA 900 2012 - NUDA 900 R 2012

Checking brake pads for wear / replacing the pads

Check brake pad wear.
Service limit "A"
- 4 mm - (0.157 in.) (front and rear pads)
If said limit has been exceeded, or if even only one of the wear indicators is no
longer visible, replace the pair of pads (in any case, the replacement is neces-
sary when the wear indicators are no longer visible).
Be careful that no brake fluid or any oil gets on brake pads or discs. Clean off
with alcohol any fluid or oil that inadvertently gets on the pads or disc.
Replace the pads with new ones if they cannot be cleaned satisfactorily.
DISASSEMBLY OF THE REAR PADS
H10864
- Remove the safety clip (1).
- Slide out pin (2).
- Remove the pads (3) making sure not to damage the pre-load clip inside the
calliper.
ASSEMBLY OF THE REAR PADS
- Install new brake pads.
- Reassemble the pin (2) making sure not to damage the pre-load clip inside
the calliper and the safety clip (1).
Acting as described above, after replacing the pads it is not necessary to bleed
the system, just act the control lever several time until the pistons get in the
H10865
normal position.
2
H10866
3
H10867
BRAKES
1
1
1
1
2
1
Do not use the brake pedal while removing the pads.
L.10