Left Clutch Side Cover Removal/Installation; Gearbox Lever Removal/Installation; Oil Dipstick Removal; Cover Removal - Husqvarna NUDA 900 R 2012 Workshop Manual

NUDA 900 2012/2013 - NUDA 900 R 2012/2013
2
1
2
1
3
GENERAL ENGINE PROCEDURES

LEFT CLUTCH SIDE COVER REMOVAL/INSTALLATION

When installing a new crankcase cover, the bearings and the gaskets
are preassembled.

Gearbox lever removal/installation

1
Removal:
- Loosen the screw (1) then remove the lever (2).
Installation:
- Fit the lever (2) and tighten the screw to torque (1).
H10207

Oil dipstick removal

Remove the oil dipstick (1).
H10208

Cover removal

- Remove the screws (1).
- Remove the gasket (2) and the cover (3), paying attention to the sealing ring
and the gearbox shaft.
- Pay attention to the thrust washer (arrow), it may stick to the crankcase cover.
H10209
F1.3
Workshop Manual Ed. 11-2011