Husqvarna NUDA 900 R 2012 Workshop Manual page 102

NUDA 900 2012/2013 - NUDA 900 R 2012/2013
9
Workshop Manual Ed. 11-2011
GENERAL PROCEDURES
6
H10844
6
7
H10845
- Install the swinging arm (8) without tightening the nut to torque (9) of the pin
(10).
- Tighten the screws (5) on the left-hand side of the chassis to torque.
10
- Tighten the screws (6) on the right-hand side of the chassis to torque.
- Tighten the nut (9) of the swinging arm to torque.
Install in a sequence the following components, as described in the relevant
paragraphs/chapters:
- Left footrest;
- Master cylinder with related cover;
- Harness;
- Exhaust assembly;
- Front end;
8
- Rear shock absorber;
- radiator with relevant pipes;
H10846
- reservoir;
- Filter box.
E.42