Gear Position Sensor Removal/Installation - Husqvarna NUDA 900 R 2012 Workshop Manual

NUDA 900 2012/2013 - NUDA 900 R 2012/2013
4
3
2
4
5
3
2
GENERAL ENGINE PROCEDURES

GEAR POSITION SENSOR REMOVAL/INSTALLATION

Removal:
- Remove the screws (1).
- Disassemble the gearbox potentiometer (2) with the sealing ring (3).
- Check the oil seal (4) for wear; if there are leaks, replace it.
To replace it, proceed as follows:
- Remove the oil seal (4).
- Insert the new oil seal (4) centring it on the shaft (5) then, using a rubber ham-
mer and a suitable punch (6), insert it in the relevant seat until the external
edge of the oil seal (4) is flush with the inside of the bevelled edge.
1
NOTE: Make sure that the inner lip of the oil seal (4) is not damaged during
installation due to the profile of the shaft.
H10242
4
5
6
H10244
Installation:
- Check the sealing ring (3), replace it if ruined, and fit it on the potentiometer
(2).
- Fit the potentiometer (2) with the sealing ring, making sure that the driver
shaft engages correctly in the potentiometer during the installation phase.
- Insert the screws (1), tightening them to torque.
1
H10245
F1.13
Workshop Manual Ed. 11-2011