Heat Exchanger Removal/Installation - Husqvarna NUDA 900 R 2012 Workshop Manual

NUDA 900 2012/2013 - NUDA 900 R 2012/2013
8
5
4
1
2
3
1
2
1
2
GENERAL ENGINE PROCEDURES
- Fit the caps (2), paying attention to the correct positioning of the centring
pins and the installation position marks.
NOTE: The caps (2) must not be inverted.
- Replace the screws (1) and tighten them manually.
- Tighten the screws (1) to torque, referring to the installation sequence (from
1 to 8)
1
- Refit the previously removed parts as described in the relevant paragraphs.
2
H10306
6
7
H10307

HEAT EXCHANGER REMOVAL/INSTALLATION

Removal:
During the installation/removal operations, make sure not to mix
liquids from different circuits.
- Drain the coolant and the oil as described in the relevant paragraphs.
- Remove the screws (1).
- Refit the heat exchanger (2).
3
- Remove the gasket (3).
H10309 Installation:
- Fit the new gasket (3).
- Fit the heat exchanger (2).
- Tighten the screws (1) to torque.
- Refill with coolant and oil as described in the relevant paragraphs.
3
H10310
F1.31
Workshop Manual Ed. 11-2011