NUDA 900 2012/2013 - NUDA 900 R 2012/2013
1
2
3
4
Workshop Manual Ed. 11-2011
GENERAL ENGINE PROCEDURES
Starter motor idle gear removal/installation
-
Remove gears (1) and (2) and check the state of wear, refit them exactly in
the correct position, making sure that a space washer is fit above the idler
gear (1).
2
1
H10234
Installation of the flywheel with freewheel control gear
-
Clean the collar and internal bearing of the freewheel gear (1) and lubricate
1
with engine oil.
-
Fit the freewheel gear (1) into the crankshaft.
-
Clean the cone of the crankshaft and of the flywheel.
-
Apply a thin layer of Loctite 648 on the crankshaft cone.
2
Pay attention that the freewheel bearing does not come into contact
with the Loctite.
H10235
-
Fit the flywheel (2) onto the crankshaft, making sure that the groove and the
key (6) are aligned and that the freewheel is set on the relevant gear (1).
-
Clean both crankshaft and flywheel (2) retaining screw threading.
-
Tighten the screw (4) to torque with the washer (3), carefully applying a thin
layer of Loctite 648 on the screw thread.
6
-
Refit the right crankcase as indicated in the relevant paragraph.
7
H10446
F1.10