NUDA 900 2012/2013 - NUDA 900 R 2012/2013
3
1
4
3
1
1
4
3
GENERAL ENGINE PROCEDURES
RIGHT ENGINE CRANKCASE REMOVAL/REPLACEMENT
-
Remove the screws (1).
1
-
Remove the cover (2) with the gasket (3).
2
H10223
Stator disassembly
-
Remove the screws (4).
-
Remove the cable gland (3).
-
Remove the screws (1).
-
Release the rubber sheath from the cover and remove the stator (2) with the
cable.
2
H10224
Stator assembly
-
Clean the threading in the cover.
-
Insert the stator in the cover, the cable support (1) must be in the slit (arrow).
H10225
-
Precisely position the stator (2) using the holes of the screws.
-
Tighten the screws (1) to the tightening torque.
-
Insert the rubber sheath in the cover.
-
Fit the cable gland (3) and the screws (4).
If the cover has been replaced, there will not be any threading as it
is created by the screw. In this case, no sealant should be used for
2
the screws, otherwise use Loctite 243.
H10226
F1.7
Workshop Manual Ed. 11-2011