Flywheel And Starter Motor Idle Gear Removal; Removal/Installation Of The Freewheel From/On The Flywheel - Husqvarna TR 650 TERRA 2013 Workshop Manual

1
1
Workshop Manual Ed.09-2012
GENERAL ENGINE PROCEDURES
TR 650 TERRA 2013 - TR 650 STRADA 2013

Flywheel and starter motor idle gear removal

- Remove the right crankcase and fix the engine at the top dead centre, as
described in the relevant paragraphs.
- Heat the flywheel hub (1) to a temperature of approx. 100°C.
- Unscrew the nut (2) and washer (3).
2
- Remove the flywheel together with the freewheel (4) using a suitable puller.
3
H11535
4
H11536

Removal/installation of the freewheel from/on the flywheel

- Heat the freewheel to about 120°C.
- Undo the screws (1), remove the flange (2) and freewheel (3).
3 2
Installation:
- Check the condition of the freewheel (3), and replace it if it is ruined.
- Install the freewheel (3) onto the flywheel with the mark (4) facing the flywheel.
- Fit the flange (2).
- Replace the screws (1) with pre-lubricated screws and tighten to torque or
use Loctite 648.
H11537
4
3
H11538
F1.10